Bathroom waterproofing in Afif: cost & published offers

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Afif for bathroom waterproofing

Main roads in or near Afif: King Abdulaziz Road, King Faisal Road, Airport Road. The centre of Afif sits about 1040 m above sea level (SRTM open elevation data).

Team note on Afif: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

How much does bathroom waterproofing cost in Afif, and what do you get for the price? In Afif, bathroom waterproofing is priced at SAR 15–40 per m², which is the published range for this work. Afif sits at a notable height, as the centre of the town is about 1040 m above sea level, but the rate you pay depends on the scope of the job rather than on location alone. Owners often compare this figure with other treatments, so it helps to know that epoxy coating runs SAR 35–90 per m² and spray foam SAR 20–45 per m². Bathroom waterproofing sits at the lower end of that scale, which suits most wet rooms and floors.

Before any quote is given, the inspection follows a clear order. The technician first checks the bathroom floor and the joints where the floor meets the walls, since water usually escapes at these points. Any cracks are noted, and where a crack is found, crack injection is priced separately at SAR 40–120 per metre, so it appears as its own line rather than being hidden in the bathroom figure. The inspector then measures the area in square metres, which is the basis for the SAR 15–40 per m² rate, and records the condition of the surface so the coating can be matched to it. The findings are explained in person, and the quote lists each item with its own rate.

To make the visit useful, prepare a few things in advance. Clear the bathroom floor and remove loose mats, rugs and anything stored along the walls so the technician can reach the edges and joints. Note any place where you have seen damp, staining or peeling paint, and mention when the problem first appeared, since this helps narrow the inspection. Have a rough measurement of the room ready if you have one, though the technician will measure it again on site. Finally, keep a record of any earlier repairs, because previous coatings can change how the new work is applied.

Prices shown on this page come from our own published price list for the city; the final price is set after inspection.

Signs worth paying attention to

The following signs are worth checking before they grow:

• Damp around the shower
• A stain under the bathroom on the floor below
• Worn grout

Where the problem usually comes from

• A damaged floor layer.
• Corners without waterproofing tape — we check this before anything else.
• A common cause: the area around the floor drain.

Tools and methods, and when we use them

From the first visit to the report

1. Finding the source: A supply-pipe leak is ruled out first.
2. Preparation: The floor is opened and cleaned where needed.
3. Corners and details: Tape and detailing at corners, drains and pipe entries.
4. Flood test: The floor is tested before tiling.

Facts and costs — Afif

Common questions about bathroom waterproofing in Afif

What we advise against

• Waterproofing the floor while the supply pipe still leaks

What you receive

You receive: the flood-test result and photos of each stage, in a technical report with a verification code.