Basement & foundation waterproofing in Albukayriyah: before summer & rain season

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Albukayriyah

The centre of Albukayriyah sits about 659 m above sea level (SRTM open elevation data).

Before any basement or foundation waterproofing work begins in Albukayriyah, the first thing a technician checks is the lie of the land. The centre of Albukayriyah sits about 659 m above sea level according to SRTM open elevation data, and that height shapes how water moves across a plot and where it tends to collect against the lower walls of a building. Because the ground is not flat in the way a coastal site might be, the surface run-off, the slope of the plot and the position of the basement relative to the street all matter before any material is chosen. Pricing for this work is set per square metre, with basement waterproofing typically in the range of SAR 50–150 per m², so the extent of the wall and floor area is one of the first measurements taken.

The detailed condition of the structure is left to the site visit. Cracks, honeycombing in the concrete, old coatings that have peeled, and any signs of damp or staining are examined by hand and with the eye at the location itself, not from a description. Crack injection, priced at SAR 40–120 per metre, is only suggested once the crack has been traced along its full length and its movement assessed. Likewise, whether an epoxy coating (SAR 35–90 per m²), a spray foam system (SAR 20–45 per m²) or a bitumen membrane (SAR 15–35 per m²) suits the surface can only be decided after the substrate has been looked at. Roof, bathroom and tank areas, where liquid roof waterproofing (SAR 8–25 per m²), bathroom waterproofing (SAR 15–40 per m²) and tank internal coating (SAR 25–60 per m²) apply, are assessed in the same way on site.

To help the technician, it is useful to have ready a clear sketch of the basement and foundation layout, the approximate wall and floor areas, any previous repair records, and a note of where water has been seen and when. Information about whether the basement is in use, whether insulation such as XPS boards (SAR 12–30 per m²) has ever been fitted, and access arrangements for the work all help the visit go smoothly. Describing where damp appears most after rain, and whether it follows the same path each time, gives the technician a reliable starting point for the inspection.

Checks before summer and before the rain season catch problems while they are still small.

Signs worth paying attention to

These are the signs most often linked to basement & foundation waterproofing:

• Water seeping in after rain
• Damp basement walls
• Salt marks at the bottom of the walls

The most common causes

• A common cause: cracks at construction joints.
• Rainwater draining towards the foundation — we check this before anything else.
• A high groundwater level.

Tools and methods, and when we use them

How the work is done, step by step

1. Finding the source: Groundwater, rain or a pipe — each needs a different treatment.
2. Preparation: Surfaces are cleaned and opened where needed.
3. Injection: Active cracks are injected.
4. Waterproofing layers: The system is applied on the right side of the wall where possible.
5. Follow-up: Readings are repeated after the treatment.

Albukayriyah in facts and sources

Questions from Albukayriyah

What we advise against

• Painting the basement wall while the water comes from outside

The written outputs

The written output: the source, the treatment and the follow-up result. The report is numbered and can be checked with its verification code.