Epoxy coating & waterproofing in Allith: before summer & rain season

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Why epoxy coating & waterproofing differs in Allith

Main roads in or near Allith: Al Laith Road, Amr Bin Al Aas Street. Allith is about 1.2 km from the sea coast (OpenStreetMap).

The centre of Allith sits about 5 m above sea level (SRTM open elevation data).

An owner of a villa or small apartment building in Allith often notices the same problems each year. Floors in a garage or storeroom look fine until a warm spell brings a sticky, dusty surface, and then a rainy week reveals damp patches on a wall or a hairline crack that wasn't there before. Many owners wait until the damage is visible, then search for a quick fix. Planning the work before summer and before the rains arrives is usually far less stressful and less costly.

The centre of Allith sits about 5 m above sea level, and the town is about 1.2 km from the sea coast. For a homeowner, this means the area is low-lying and close enough to the coast that salty, humid air and surface water can affect exposed concrete and finishes. Water does not always drain away quickly, so basements, ground-floor slabs and roofs can hold moisture longer than expected. Heat in summer can also open small cracks, which then let water in when the rain comes. Choosing the right protection for each part of the building, rather than one product for everything, makes the most sense in this setting.

Start by walking the property after a dry spell and marking every crack, damp stain and worn area on a simple sketch. Next, decide which surfaces need what: epoxy coating (SAR 35–90 per m²) suits garage and workshop floors, spray foam (SAR 20–45 per m²) can serve for some exposed areas, and liquid roof waterproofing (SAR 8–25 per m²) or a bitumen membrane (SAR 15–35 per m²) is often used on flat roofs. Repair cracks first, since crack injection is priced at SAR 40–120 per metre, and let the repairs cure before any coating goes on. Then treat wet rooms, where bathroom waterproofing runs SAR 15–40 per m², and basements, where basement waterproofing costs SAR 50–150 per m². Finally, if the property has a water tank, consider tank internal coating at SAR 25–60 per m², and add XPS boards (SAR 12–30 per m²) where insulation and moisture control are both needed. Book the work early, so the surfaces are ready before the hot season and the rains.

Checks before summer and before the rain season catch problems while they are still small.

When do you need epoxy coating & waterproofing?

These are the signs most often linked to epoxy coating & waterproofing:

• Oil stains on a floor
• A warehouse floor that is wearing away
• A tank that needs an easy-to-clean surface

Where the problem usually comes from

• A damp surface that ruins adhesion.
• Insufficient preparation — we check this before anything else.

How we choose the tool in Allith

From the first visit to the report

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Facts and costs — Allith

Questions from Allith

What we advise against

• Coating over a damp surface

What you receive

You receive: the epoxy system, thickness and curing time, in a technical report with a verification code.