Basement & foundation waterproofing in Badr: with a verifiable technical report

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Badr for basement & foundation waterproofing

The centre of Badr sits about 109 m above sea level (SRTM open elevation data). Team note on Badr: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

Picture a homeowner in Badr who has a basement used as a storage room or a family space. After a heavy rain, a damp patch appears on the lower wall, and a faint musty smell settles in. They are not sure whether the water is coming through the floor, the wall, or a crack near the corner, and they want to know what a repair should cost before they call anyone. Many owners in this position wait too long, because the damage looks minor at first and then spreads to finishes and fixtures.

Badr sits at roughly 109 m above sea level, which means the land is not especially low-lying, but this does not spare a basement from ground moisture. Water finds its way through the soil around the foundation and pushes against the walls, so the first task is to find where it enters rather than assuming the whole structure has failed. Pricing also varies a lot by method: basement waterproofing is typically quoted between SAR 50 and SAR 150 per m², while crack injection is priced per metre, between SAR 40 and SAR 120 per m. Knowing which unit applies to your problem helps you compare quotes fairly and avoid paying for an area treatment when a single crack is the real issue.

Start by walking the basement after rain and marking every damp patch, crack, and stain with a pencil so you can see the pattern. Measure the affected wall and floor areas and note any cracks with their lengths. Next, compare the marked areas against the methods on offer, such as epoxy coating at SAR 35 to SAR 90 per m², spray foam at SAR 20 to SAR 45 per m², or a bitumen membrane at SAR 15 to SAR 35 per m², and ask each provider which one suits your wall. Then request written quotes that state the unit price and total area, so the figures can be checked line by line. Finally, schedule the work for a dry period and confirm the finished surface is free of new moisture before you refinish the room.

Each job ends with a written report that carries a verification code you can check on our site.

When do you need basement & foundation waterproofing?

If you notice one of these signs in Badr, it is a good moment to talk to the team:

• Water seeping in after rain
• Damp basement walls
• Salt marks at the bottom of the walls

Causes we see in the field

• Cracks at construction joints.
• A common cause: rainwater draining towards the foundation.
• A high groundwater level — we check this before anything else.

Tools and methods, and when we use them

From the first visit to the report

1. Finding the source: Groundwater, rain or a pipe — each needs a different treatment.
2. Preparation: Surfaces are cleaned and opened where needed.
3. Injection: Active cracks are injected.
4. Waterproofing layers: The system is applied on the right side of the wall where possible.
5. Follow-up: Readings are repeated after the treatment.

Facts and costs — Badr

Short answers for Badr

What we advise against

• Painting the basement wall while the water comes from outside

What you get after the work

The written output: the source, the treatment and the follow-up result. The report is numbered and can be checked with its verification code.