Epoxy coating & waterproofing for restaurants in Jeddah
In short: Epoxy coating & waterproofing for restaurants in Jeddah starts with the moisture meter for ceilings and walls, then the thickness measurement at spread-out points, before anything is opened. Jeddah is about 2 km from the sea coast (OpenStreetMap). Pricing starts from Epoxy coating (per m²) (SAR 35–95 per m²), and other items are quoted after the visit.
Before we start: what we know about Jeddah
Team note on Jeddah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. Jeddah is about 2 km from the sea coast (OpenStreetMap).
The centre of Jeddah sits about 15 m above sea level (SRTM open elevation data).
A restaurant owner in Jeddah usually has a kitchen that must stay clean and dry, a back-of-house storage area, and often a basement or service room that sees regular water and heat. Over time, moisture can creep through floors and walls, and the owner may notice flaking surfaces, stains, or a smell that customers and inspectors will not overlook. The goal is a floor and wall finish that resists grease, washing water, and humidity, and a waterproofing layer below any area that is partly underground.
Jeddah's terrain shapes these decisions. The centre of the city sits about 15 m above sea level, so ground drainage differs from low coastal sites, but the city is still only about 2 km from the sea coast, which keeps the air humid and salty. That combination means moisture from the air and from washing can settle on surfaces, and salt-laden damp can attack concrete over time. For a restaurant, a seamless epoxy coating on kitchen floors and walls is a practical answer, because it closes surface pores and can be wiped clean after every service. Where a basement or storage room is involved, the cost range for basement waterproofing (SAR 55–160 per m²) should be weighed against the risk of leaks reaching stored stock and equipment.
A sensible order of work starts with a site check: look for cracks, damp patches, and any water entering from outside. Next, seal any cracks, because crack injection is priced per metre (SAR 40–125 per m) and must be done before coating. Then prepare the surface, since epoxy coating (SAR 35–95 per m²) only bonds well to clean, dry concrete. Apply the coating to the kitchen and service areas, and treat the basement with basement waterproofing where needed. Finally, check the roof, where liquid roof waterproofing (SAR 10–25 per m²) can protect the building from above. Leave each layer to cure fully before moving to the next, and schedule works outside peak trading hours so the kitchen can keep serving guests.
For restaurants, visits are planned outside service hours and recorded for the premises file.
Signs worth paying attention to
These are the signs most often linked to epoxy coating & waterproofing:
- Oil stains on a floor
- A warehouse floor that is wearing away
- A tank that needs an easy-to-clean surface
The most common causes
- A common cause: a damp surface that ruins adhesion.
- Insufficient preparation — we check this before anything else.
How we choose the tool in Jeddah
| Tool | What it finds | When we use it in Jeddah |
|---|---|---|
| Thickness measurement at spread-out points | Whether the thickness in the quote was achieved | Limits: for foam and liquid-applied layers |
| Moisture meter for ceilings and walls | Where water is entering now, from inside | Limits: measures the effect, not the water path |
| Fill test with level monitoring | Whether a tank coating holds after the work | Limits: takes time to monitor the level |
How the work is done, step by step
- Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
- Careful preparation: Grinding and cleaning for adhesion.
- Layers: Primer and body coats as specified.
- Inspection: Thickness and curing are checked.
Jeddah in facts and sources
| Item | Value | Source |
|---|---|---|
| District profile | Team note on Jeddah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins. | Kashf team |
| District profile | The centre of Jeddah sits about 15 m above sea level (SRTM open elevation data) | SRTM (NASA) open data |
| District profile | Jeddah is about 2 km from the sea coast (OpenStreetMap) | © OpenStreetMap contributors (ODbL) |
| Epoxy coating (per m²) | SAR 35–95 per m² | Owner price list (Jeddah) |
Common questions about epoxy coating & waterproofing in Jeddah
Can I use household chemicals instead of calling a technician?
Using unsuitable chemicals may corrode pipes and does not fix the root cause of the blockage, so it is better to rely on a specialist technician.
What is the difference between foam insulation and other types of insulation?
Foam insulation is easy to apply on uneven surfaces and forms one continuous layer with no joints, while other types, such as bitumen rolls, need the joints to be welded. The contractor decides which is most suitable after inspecting the site.
Can thermal insulation be applied to an existing building?
Yes, thermal insulation can be installed on the roofs and walls of existing buildings without the need for major structural modifications. The contractor prepares the surface, then applies the insulating material and the protective layer over it.
Where does epoxy coating & waterproofing for restaurants start in Jeddah?
We start with surface moisture reading (epoxy is applied only when the substrate is dry enough), then careful preparation (grinding and cleaning for adhesion).
What does epoxy coating & waterproofing cost in Jeddah?
From our published price list: Epoxy coating (per m²) SAR 35–95 per m². Quantities are confirmed at the inspection.
What do I receive after the work?
The epoxy system, thickness and curing time, in a technical report that carries a verification code.
Common mistakes we see
- Coating over a damp surface
What you get after the work
The written output: the epoxy system, thickness and curing time. The report is numbered and can be checked with its verification code.
Planning the visit in Jeddah
- The Saudi weekend is Friday and Saturday; mention your preferred day and time when booking.
- You can message us on WhatsApp in English; the booking details are sent back to you in the chat to confirm before the visit.
- If you rent, tell your landlord or building management before the visit and agree in writing who pays; the written report can be shared with them.
- Keep photos of the problem and of any earlier repairs — they help the technician compare before and after.
Sources and method
- SRTM (NASA) open data
- © OpenStreetMap contributors (ODbL)
- Kashf team
- Customer questions (reviewed)
- Owner price list for Jeddah
- Local pages are published only after a quality gate: real local facts, text similarity of no more than 15% with any other English page, and a claims check.
- النسخة العربية