Epoxy coating & waterproofing for hotels & serviced apartments in Jubail

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Epoxy coating & waterproofing in Jubail: the local context

Jubail is about 0.9 km from the sea coast (OpenStreetMap). The centre of Jubail sits about 4 m above sea level (SRTM open elevation data).

Team note on Jubail: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

Epoxy coating and waterproofing for hotels and serviced apartments usually starts with one recurring problem: moisture getting into floors, basements and wet areas that see heavy daily use. Guest bathrooms, service corridors and car park levels are walked on, cleaned and splashed constantly, so a coating that fails at joints or cracks lets water track into the structure. For a property that depends on guest reviews and steady occupancy, a small leak in a bathroom or a damp patch in a basement can turn into a costly and disruptive repair.

Jubail changes how we approach this work. The centre of Jubail sits about 4 m above sea level, and Jubail is about 0.9 km from the sea coast, so salt-laden air and a high local water table are real considerations for ground-level and below-ground areas. Our approach therefore starts with checking the substrate and the moisture risk before choosing a system. Basement waterproofing typically falls in the range of SAR 50–150 per m², bathroom waterproofing in the range of SAR 15–40 per m², and epoxy coating in the range of SAR 35–90 per m². Where a site needs a crack repaired first, crack injection is priced at SAR 40–120 per metre, and a bitumen membrane at SAR 15–35 per m² or XPS boards at SAR 12–30 per m² may suit certain below-ground details. The right combination depends on what we find on site, not on a single standard package.

Before the visit, ask the provider a few clear questions. Ask which areas they will inspect, whether the survey covers basements, wet rooms and roof sections, and how they will check for moisture before any coating goes down. Ask for a written scope that lists each area and the method proposed for it, and confirm how the per-square-metre or per-metre rates will be applied to your measured quantities. Finally, ask how the work will be scheduled around guest occupancy, so that rooms and corridors can be closed off in stages with minimal disruption to your guests.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

When do you need epoxy coating & waterproofing?

The following signs are worth checking before they grow:

• A warehouse floor that is wearing away
• A tank that needs an easy-to-clean surface
• Oil stains on a floor

Where the problem usually comes from

• A damp surface that ruins adhesion.
• Insufficient preparation — we check this before anything else.

Tools we use in Jubail

From the first visit to the report

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Jubail in facts and sources

Short answers for Jubail

Mistakes that cost more

• Coating over a damp surface

The written outputs

You receive: the epoxy system, thickness and curing time, in a technical report with a verification code.