Wall damp treatment for rest houses & farms in Makkah

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Why wall damp treatment differs in Makkah

Team note on Makkah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Makkah sits about 301 m above sea level (SRTM open elevation data).

Makkah's city centre sits about 301 m above sea level (SRTM open elevation data), in a hot, dry valley ringed by mountains. For rest houses and farms, this matters because the desert climate brings sharp day-night temperature swings that stress render and masonry, while the rare but heavy rains that run off surrounding slopes can push water toward low walls and foundations. Our assessments start by looking at where water actually enters a property, rather than applying one treatment across the whole building.

Those site conditions shape the scope and the price. Basement waterproofing is quoted at SAR 55–160 per m², and bathroom waterproofing at SAR 15–40 per m², because wet areas are usually the first place damp shows up and need a dedicated membrane. Epoxy coating at SAR 35–95 per m² and spray foam at SAR 20–45 per m² suit walls where the surface needs sealing, while crack injection at SAR 40–125 per metre is used where the damp traces back to a specific fissure rather than the wall as a whole. Liquid roof waterproofing at SAR 10–25 per m² and bitumen membrane at SAR 15–35 per m² protect roofs that take the full sun and occasional downpour. Tank internal coating at SAR 25–65 per m² and XPS boards at SAR 15–30 per m² round out the options for farm water storage and insulated walls. The practical effect is that every job is priced by surface type and by the exact area needing protection, so owners pay for the treatment their building needs.

Owners of rest houses and farms often make the same few errors, and this service is designed to avoid them. The most common is painting over damp without fixing the source, which only hides the stain until the next rainfall. Another is ordering full-wall treatment when a single crack injection or bathroom membrane would solve the problem. Some also skip the basement or foundation check and only treat visible patches, leaving water to travel behind the new finish. Finally, many owners delay roof work until leaks reach the ceiling. We address each of these by mapping the water path first, then recommending only the works that stop it.

Rest houses and farms often have long buried lines, tanks and irrigation that need separate tests.

When do you need wall damp treatment?

If you notice one of these signs in Makkah, it is a good moment to talk to the team:

• Black spots on the wall
• A musty smell
• Peeling paint and salt marks

Where the problem usually comes from

• A common cause: rising damp from the ground.
• A leaking pipe.
• Condensation.

Tools we use in Makkah

From the first visit to the report

1. Moisture readings: Readings are taken in a grid across the wall.
2. Finding the cause: Pipe, condensation or rising damp.
3. Treatment: The cause is treated before the finish.
4. Finishing: Plaster and paint after the wall has dried.

Makkah in facts and sources

Questions from Makkah

What we advise against

• Painting over damp

What you receive

The written output: the cause and the proposed treatment. The report is numbered and can be checked with its verification code.