Epoxy coating & waterproofing for hotels & serviced apartments in Qatif

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Epoxy coating & waterproofing in Qatif: the local context

The centre of Qatif sits about 5 m above sea level (SRTM open elevation data). Qatif is about 2.5 km from the sea coast (OpenStreetMap).

Team note on Qatif: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

Qatif sits about 5 m above sea level, and its centre is roughly 2.5 km from the sea coast. That combination matters for hotels and serviced apartments. Low-lying ground and proximity to the coast mean moisture can rise through basements and slabs, and salty, humid air works on exposed surfaces over time. Our epoxy coating and waterproofing work is planned around these conditions, so that the protection suits the damp and salt exposure a building in this area actually faces.

Each fact has a practical effect on how we work. Because the centre sits only about 5 m above sea level, we check ground moisture and drainage before recommending a system, since water can press upward against lower floors and car parks. Because the site is about 2.5 km from the coast, we pay attention to salt-laden air, choosing coatings that resist it and preparing surfaces carefully so the film bonds well. Pricing is set per square metre or per metre of crack, with ranges for basement waterproofing at SAR 50–150 per m², bathroom waterproofing at SAR 15–40 per m², epoxy coating at SAR 35–90 per m², and crack injection at SAR 40–120 per metre, so owners can match the method to each area of the property.

Owners of hotels and serviced apartments in this area commonly avoid a few costly errors. They do not coat over damp or dusty concrete, because adhesion fails when moisture is trapped beneath the film. They do not treat cracks as cosmetic, since an open crack lets water through even under a good coating. They also avoid choosing one system for every surface, when a roof, a tank and a wet room each need a different material such as liquid roof waterproofing at SAR 8–25 per m², tank internal coating at SAR 25–60 per m², or XPS boards at SAR 12–30 per m². Matching the system to the surface is what keeps guest areas dry and the building protected for longer.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

Signs worth paying attention to

If you notice one of these signs in Qatif, it is a good moment to talk to the team:

• A tank that needs an easy-to-clean surface
• A warehouse floor that is wearing away
• Oil stains on a floor

The most common causes

• Insufficient preparation — we check this before anything else.
• A damp surface that ruins adhesion.

How we choose the tool in Qatif

How the work is done, step by step

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Facts and costs — Qatif

Short answers for Qatif

Common mistakes we see

• Coating over a damp surface

What you get after the work

The written output: the epoxy system, thickness and curing time. The report is numbered and can be checked with its verification code.