Bathroom waterproofing for hotels & serviced apartments in Tabuk

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Tabuk

Team note on Tabuk: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Tabuk sits about 762 m above sea level (SRTM open elevation data).

The centre of Tabuk sits about 762 m above sea level, which places the city on a high plateau rather than on the coast. For bathroom waterproofing in hotels and serviced apartments, this matters because altitude brings a different climate mix from the lowlands: hot, dry days and cooler nights can make surfaces expand and contract, so the membrane must stay flexible rather than brittle. We therefore treat each bathroom as a system that must handle movement, not just a flat surface to be sealed once and forgotten.

Bathroom waterproofing in our service is priced at SAR 15–40 per m², and the final figure depends on the surface, its condition and how many wet areas the room contains. Epoxy coating, at SAR 35–85 per m², is often chosen for high-traffic bathrooms because it forms a hard, continuous film that resists frequent cleaning and heavy use, while spray foam at SAR 20–45 per m² suits irregular shapes and corners where a roller or brush would leave gaps. Where a wall or floor shows a hairline fault, crack injection at SAR 40–115 per m can seal the line before the new layer goes on, so that water does not travel behind the finished surface.

Owners in Tabuk avoid several common mistakes that shorten the life of a bathroom. They do not apply a coating over damp or dusty substrate, because the film will lift within months. They do not skip the corners and the joints around the shower tray and pipe penetrations, which is where most leaks begin. They do not rely on a single thin coat when the drawings call for two, and they do not allow guests to use the room before the membrane has fully cured. Each of these shortcuts saves little at the start and costs far more when tiles loosen and ceilings below are damaged.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

When do you need bathroom waterproofing?

These are the signs most often linked to bathroom waterproofing:

• Worn grout
• Damp around the shower
• A stain under the bathroom on the floor below

Where the problem usually comes from

• A common cause: the area around the floor drain.
• A common cause: a damaged floor layer.
• Corners without waterproofing tape — we check this before anything else.

Tools we use in Tabuk

How the work is done, step by step

1. Finding the source: A supply-pipe leak is ruled out first.
2. Preparation: The floor is opened and cleaned where needed.
3. Corners and details: Tape and detailing at corners, drains and pipe entries.
4. Flood test: The floor is tested before tiling.

Tabuk in facts and sources

Short answers for Tabuk

Mistakes that cost more

• Waterproofing the floor while the supply pipe still leaks

What you receive

You receive: the flood-test result and photos of each stage, in a technical report with a verification code.