Epoxy coating & waterproofing in Tabuk: for companies (annual contract)

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Tabuk for epoxy coating & waterproofing

Team note on Tabuk: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Tabuk sits about 762 m above sea level (SRTM open elevation data).

Tabuk sits in the far northwest of Saudi Arabia, and the centre of the city lies about 762 m above sea level (SRTM open elevation data). That height matters for commercial buildings. Sites at this elevation see a wide daily temperature swing, which stresses coatings, joints and concrete surfaces over time. For companies with warehouses, workshops, staff facilities or storage tanks, the surface protection chosen should tolerate heat by day and cooler nights without softening or cracking.

Because of that climate, our epoxy coating and waterproofing work starts with a site check before any price is set. Epoxy coating is quoted in the range of SAR 35–85 per m², with the final rate depending on floor condition, traffic and finish. Tank internal coating runs SAR 25–55 per m², and crack injection is priced SAR 40–115 per metre, so a surveyor can match the method to the stress the surface will face. Where a roof is exposed, liquid roof waterproofing at SAR 10–25 per m² or a bitumen membrane at SAR 15–35 per m² may suit the building better than a single product applied everywhere. Spray foam, at SAR 25–35 per m², is another option for certain roof and wall areas, and XPS boards at SAR 10–30 per m² can add insulation where it is needed.

Business owners in Tabuk often avoid the same few mistakes. The first is comparing quotes by the lowest rate alone, without checking what preparation is included, since a thin coat over a dusty or damp floor fails early. The second is treating basements and bathrooms the same way: basement waterproofing, quoted at SAR 50–145 per m², handles water pressure from outside, while bathroom waterproofing at SAR 15–40 per m² is designed for splashes and steam. The third is delaying repairs on small cracks, which are far cheaper to inject than to rebuild. A clear site survey before work begins prevents all three problems.

For companies, an annual contract sets the scope, the visit schedule and the reports in writing.

Signs that call for epoxy coating & waterproofing

If you notice one of these signs in Tabuk, it is a good moment to talk to the team:

• Oil stains on a floor
• A warehouse floor that is wearing away
• A tank that needs an easy-to-clean surface

The most common causes

• A damp surface that ruins adhesion — we check this before anything else.
• A common cause: insufficient preparation.

How we choose the tool in Tabuk

How the work is done, step by step

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Facts and costs — Tabuk

Short answers for Tabuk

What we advise against

• Coating over a damp surface

What you receive

You receive: the epoxy system, thickness and curing time, in a technical report with a verification code.