Epoxy coating & waterproofing for hotels & serviced apartments in Tabuk

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Tabuk for epoxy coating & waterproofing

Team note on Tabuk: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Tabuk sits about 762 m above sea level (SRTM open elevation data).

Tabuk sits in the north-west of Saudi Arabia, and the centre of the city lies about 762 m above sea level (SRTM open elevation data). That height matters for buildings here. Hotels and serviced apartments in the city face a dry, high-altitude climate with wide daily temperature swings, and these conditions stress concrete, render and coatings in ways that a low coastal site may not. Our service for this page is planned around that setting, so the advice below reflects local building conditions rather than a generic approach.

Because the centre is at this elevation, we start every job with a close look at the existing surfaces. Thermal movement from hot days and cooler nights tends to open hairline cracks in slabs and walls, so we first map where cracks run and how wide they are. Crack injection is priced at SAR 40–115 per metre, which makes it a cost-effective first step before any surface coating is applied. For basements, where water pressure from the ground is the main risk, basement waterproofing ranges from SAR 50–145 per m², and we match the system to the actual exposure rather than applying one product everywhere. Bathrooms in busy guest wings are treated separately, at SAR 15–40 per m², because they see constant water and need a different membrane.

For the floors and wet areas that guests and staff use every day, epoxy coating at SAR 35–85 per m² gives a hard, cleanable finish that suits corridors, kitchens and plant rooms. Spray foam at SAR 25–35 per m² and XPS boards at SAR 10–30 per m² help with insulation and moisture control on walls and below slabs. Roofs in Tabuk take the sun hard, so liquid roof waterproofing at SAR 10–25 per m² and bitumen membrane at SAR 15–35 per m² are chosen according to the roof's slope and access. Water tanks, often overlooked, are coated internally at SAR 25–55 per m² to keep the water clean for guests.

Owners who engage us commonly avoid several mistakes. They do not paint over active cracks, since the coating will split again within months. They do not skip surface preparation, because epoxy and membranes fail quickly on dusty or damp concrete. They do not assume one system fits every area, and they do not delay roof work until a leak reaches a guest room. Finally, they avoid comparing quotes that cover different scopes, so every estimate we give states the area, the system and the thickness it includes.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

When do you need epoxy coating & waterproofing?

These are the signs most often linked to epoxy coating & waterproofing:

• A warehouse floor that is wearing away
• A tank that needs an easy-to-clean surface
• Oil stains on a floor

The most common causes

• A damp surface that ruins adhesion.
• Insufficient preparation — we check this before anything else.

Tools and methods, and when we use them

How the work is done, step by step

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Facts and costs — Tabuk

Short answers for Tabuk

What we advise against

• Coating over a damp surface

What you receive

You receive: the epoxy system, thickness and curing time, in a technical report with a verification code.