Floor & balcony waterproofing for rest houses & farms in Taif

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Floor & balcony waterproofing in Taif: the local context

The centre of Taif sits about 1673 m above sea level (SRTM open elevation data). Team note on Taif: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

Picture a family who owns a rest house in the hills above Taif. They spend weekends there in cooler months, and in the summer they rent it out to visitors. Between seasons the building sits empty for long stretches, and when they return they often find a damp patch on a balcony slab, a hairline crack near a railing, or a stain spreading across a farm store's ceiling. Their question is simple: what should be done to the floors and balconies before the next rains, and how much should it roughly cost?

Taif sits at about 1673 m above sea level, so the air is noticeably cooler than in the coastal cities and the temperature swings between day and night can be wide. For a rest house or farm, that matters. Cooler nights and occasional rain give moisture time to sit on exposed concrete, and the repeated expansion and contraction of slabs can open cracks that let water reach the structure below. Owners of higher-altitude properties should therefore treat balconies and roofs as the first line of defence, not an afterthought. Budgeting by area helps: liquid roof waterproofing typically falls within SAR 10–25 per m², bitumen membrane within SAR 15–35 per m², and spray foam within SAR 25–45 per m², while crack injection is priced SAR 40–115 per m.

A sensible sequence begins with a walk-through after the dry season, marking every crack and any ponding area on the balcony or roof. Next, seal the cracks by crack injection, since a sound repair underneath everything else prevents the most expensive damage later. Then choose the surface system that suits the use: epoxy coating at SAR 35–85 per m² for balconies that take foot traffic, or a bitumen membrane for roofs exposed to sun. Where a farm stores water, tank internal coating at SAR 25–55 per m² protects the reservoir. Finish by checking drainage outlets so water leaves the slab rather than pooling against the edges, and schedule a light inspection before each rainy period.

Rest houses and farms often have long buried lines, tanks and irrigation that need separate tests.

When do you need floor & balcony waterproofing?

The following signs are worth checking before they grow:

• Damp under the light well
• Water passing from the balcony to the floor below
• A wrong fall towards the door threshold

Where the problem usually comes from

• A blocked drain — we check this before anything else.
• A threshold without waterproofing — we check this before anything else.
• Incorrect falls — we check this before anything else.

Tools we use in Taif

How the work is done, step by step

1. Checking the falls: Where water collects and where it should go.
2. Details: Thresholds, drains and upstands.
3. Waterproofing: The layer is applied and protected.
4. Flood test: Tested before the finish goes on.

Facts and costs — Taif

Common questions about floor & balcony waterproofing in Taif

Common mistakes we see

• Tiling a balcony without waterproofing

The written outputs

You receive: the flood result and photos of the details, in a technical report with a verification code.