Epoxy coating & waterproofing for clinics in Alqunfudhah

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Alqunfudhah

Team note on Alqunfudhah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. Alqunfudhah is about 0.4 km from the sea coast (OpenStreetMap).

The centre of Alqunfudhah sits about 7 m above sea level (SRTM open elevation data).

Before any material is chosen for a clinic in Alqunfudhah, the first check is the ground itself. The centre of Alqunfudhah sits about 7 m above sea level, and the town is about 0.4 km from the sea coast. Those two facts matter together: a site this close to the coast and this low in elevation can see damp rising from below and salt-laden moisture reaching surfaces that would stay dry inland. For a clinic, where floors must be cleanable and walls must resist staining, the first question is whether the substrate is holding water at all. That is why the crew starts with the wet areas and below-grade slabs rather than the visible finishes.

Several things are left to the site visit, because they cannot be judged from a distance. The technician needs to see the actual moisture level in the slab, whether cracks are active or old, how the existing drainage falls, and whether any previous coating has started to lift. Clinic layouts also differ widely, so the extent of the work, the number of wet rooms, and the condition of any tank or basement must be measured on the ground. Pricing in this area runs by the square metre or the metre of crack, so the exact quantities are confirmed only after measuring. The visit is also the time to agree access hours so that treatment rooms can be sealed off and reopened without disrupting patients.

The information below helps the technician plan the work. Epoxy coating for floors is priced at SAR 35–90 per m², while bathroom waterproofing runs at SAR 15–40 per m², and basement waterproofing at SAR 50–150 per m². Spray foam is SAR 20–45 per m², liquid roof waterproofing SAR 8–25 per m², and bitumen membrane SAR 15–35 per m². Crack injection is SAR 40–120 per metre, and tank internal coating SAR 25–60 per m². XPS boards, where insulation is part of the scope, are SAR 12–30 per m². Bring these ranges to the visit so the client understands how each area of the clinic is costed.

For clinics, work is scheduled around patient hours and kept to the areas that need it.

When do you need epoxy coating & waterproofing?

If you notice one of these signs in Alqunfudhah, it is a good moment to talk to the team:

• Oil stains on a floor
• A warehouse floor that is wearing away
• A tank that needs an easy-to-clean surface

Causes we see in the field

• A damp surface that ruins adhesion — we check this before anything else.
• Insufficient preparation — we check this before anything else.

Tools we use in Alqunfudhah

From the first visit to the report

1. Surface moisture reading: Epoxy is applied only when the substrate is dry enough.
2. Careful preparation: Grinding and cleaning for adhesion.
3. Layers: Primer and body coats as specified.
4. Inspection: Thickness and curing are checked.

Facts and costs — Alqunfudhah

Common questions about epoxy coating & waterproofing in Alqunfudhah

Mistakes that cost more

• Coating over a damp surface

What you get after the work

You receive: the epoxy system, thickness and curing time, in a technical report with a verification code.