Bathroom waterproofing for hotels & serviced apartments in Baqiq

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Baqiq for bathroom waterproofing

Team note on Baqiq: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Baqiq sits about 83 m above sea level (SRTM open elevation data).

Main roads in or near Baqiq: King Fahd Road.

Bathroom waterproofing work in Baqiq starts with the place itself. The centre of Baqiq sits about 83 m above sea level (SRTM open elevation data), which means the technician checks how water is likely to move across the building before anything else. Because the site is not at sea level, drainage falls and outlets are looked at first, so that the floor slope, drain position and any standing water are recorded before a rate is discussed. For bathroom waterproofing, the typical range is SAR 15–40 per m², and that range is only meaningful once the wet area's real condition is known.

Some things cannot be judged from a description and are left to the site visit. The technician walks the room, tests the floor for hollow sounds, looks at tile joints and silicone around the bath and shower tray, and checks the wall junctions for past leaks or staining. The choice between an epoxy coating (SAR 35–90 per m²), a spray foam (SAR 20–45 per m²) or a cementitious system depends on what is already there and on how the room is used in a serviced apartment or hotel bathroom with daily turnover. Any cracks are measured in place, since crack injection is priced per metre (SAR 40–120 per m) and the length cannot be estimated from a phone call.

Information that helps the technician is simple and useful. Tell us the number of bathrooms, the approximate floor area of each wet room, whether tiles are already lifted or loose, and how long the property has been occupied since the last works. Note any water seeping into the room below or into a neighbouring unit, and any past repairs. Photos of the floor, drain and skirting taken in daylight make the first assessment faster. With this in hand, the technician can plan the visit properly and avoid repeat trips to your Baqiq property.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

When do you need bathroom waterproofing?

If you notice one of these signs in Baqiq, it is a good moment to talk to the team:

• Worn grout
• A stain under the bathroom on the floor below
• Damp around the shower

Where the problem usually comes from

• The area around the floor drain — we check this before anything else.
• Corners without waterproofing tape — we check this before anything else.
• A damaged floor layer.

Tools and methods, and when we use them

From the first visit to the report

1. Finding the source: A supply-pipe leak is ruled out first.
2. Preparation: The floor is opened and cleaned where needed.
3. Corners and details: Tape and detailing at corners, drains and pipe entries.
4. Flood test: The floor is tested before tiling.

Quick comparison: facts and costs in Baqiq

Questions from Baqiq

What we advise against

• Waterproofing the floor while the supply pipe still leaks

What you receive

The written output: the flood-test result and photos of each stage. The report is numbered and can be checked with its verification code.