Spray foam insulation for apartments in Makkah
In short: Spray foam insulation for apartments in Makkah starts with the roof, falls and drains survey, then the thickness measurement at spread-out points, before anything is opened. The centre of Makkah sits about 301 m above sea level (SRTM open elevation data). Pricing starts from Spray foam (per m²) (SAR 25–35 per m²), and other items are quoted after the visit.
Before we start: what we know about Makkah
Team note on Makkah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Makkah sits about 301 m above sea level (SRTM open elevation data).
Makkah's city centre sits about 301 m above sea level (SRTM open elevation data), a fact that shapes how spray foam insulation is planned for apartments here. At this elevation, the surrounding terrain is open and sun-exposed, so rooftops and external walls absorb heat through much of the day. Installers working on apartment blocks in the city centre therefore pay close attention to thermal gain through the roof and exterior walls, since these surfaces carry the greatest load from the desert sun.
Each of these local conditions translates into a practical effect on the work. Because the centre is at 301 m above sea level, the surfaces most exposed to daytime heat are the roof and external walls, so the spray foam application focuses there first and the coverage is planned around these areas. The rate for spray foam is SAR 25–35 per m², and that figure is what owners should use as the baseline when measuring roof and wall area. Where the property has a flat roof, a liquid roof waterproofing layer at SAR 10–25 per m² is often considered alongside the foam so that the insulation and the water barrier are handled in a single, coordinated visit. Basement levels and ground-floor bathrooms carry separate costs, with basement waterproofing at SAR 55–160 per m² and bathroom waterproofing at SAR 15–40 per m², so these areas are quoted on their own rather than folded into the insulation figure.
Owners who plan well tend to avoid a few common mistakes. They do not measure only the floor area and forget the roof and walls, which is where the foam does most of its work. They do not skip the crack injection, priced at SAR 40–125 per metre, when hairline cracks are present, since an unsealed crack lets water and heat in regardless of the foam. They also avoid treating the whole job as one undifferentiated price, instead asking for each surface to be listed separately with its own rate. Finally, they check that the chosen method suits the site, rather than applying a single standard solution to every building in the city.
In apartment buildings, the floor below is often where a leak shows first.
Signs that call for spray foam insulation
The following signs are worth checking before they grow:
- Leaks from the panel joints
- A hot metal-sheet roof or hangar
- Thermal and water insulation needed together
Causes we see in the field
- Joints in metal sheets and sandwich panels.
- A common cause: no UV protection on the surface.
How we choose the tool in Makkah
| Tool or method | What it measures | Why it is chosen here |
|---|---|---|
| Flood test | Whether the waterproofing holds before it is covered | Limits: for roofs with drains and wet areas before tiling |
| Thickness measurement at spread-out points | Whether the thickness in the quote was achieved | Limits: for foam and liquid-applied layers |
| Roof, falls and drains survey | Ponding areas and the condition of the old layer | Limits: shows the condition, not the material alone |
The steps in order
- Survey: Joints, fixings and gutters are checked.
- Preparation: The surface is cleaned and dried.
- Spraying in layers: Foam is applied in passes to the agreed thickness.
- Protection: A UV-resistant top coat protects the foam.
Facts and costs — Makkah
| Item | Value | Source |
|---|---|---|
| District profile | The centre of Makkah sits about 301 m above sea level (SRTM open elevation data) | SRTM (NASA) open data |
| District profile | Team note on Makkah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins. | Kashf team |
| Spray foam (per m²) | SAR 25–35 per m² | Owner price list (Makkah) |
Short answers for Makkah
What does finishing work typically include?
It covers plastering, painting, flooring, stone or marble walls, ceilings, gypsum, doors, windows, and final electrical and plumbing installations. You can request full or partial finishing, with the scope clearly defined in the price quote.
Is it possible to renovate the building without evacuating the residents?
In many cases it can be carried out in phases without a full evacuation if the damage is limited. However, for extensive structural renovation, a temporary evacuation may be recommended to ensure safety, and the contractor will explain this in their proposal.
Does waterproofing require removing existing tiles?
It depends on the site condition. Sometimes surface waterproofing can be applied over tiles, while deep leaks require tile removal to treat the layer underneath. A technician will determine the best option after inspection.
Where does spray foam insulation for apartments start in Makkah?
We start with survey (joints, fixings and gutters are checked), then preparation (the surface is cleaned and dried).
What does spray foam insulation cost in Makkah?
From our published price list: Spray foam (per m²) SAR 25–35 per m². Quantities are confirmed at the inspection.
What do I receive after the work?
Thickness, density and materials in the quality record, in a technical report that carries a verification code.
Common mistakes we see
- Leaving foam exposed to the sun without protection
The written outputs
The written output: thickness, density and materials in the quality record. The report is numbered and can be checked with its verification code.
Planning the visit in Makkah
- Keep photos of the problem and of any earlier repairs — they help the technician compare before and after.
- If you rent, tell your landlord or building management before the visit and agree in writing who pays; the written report can be shared with them.
- Have access ready to the water meter, the tank hatches, the roof and the main valve; in apartment buildings the roof keys are often with the building guard (haris).
- Prices are in Saudi riyals (SAR); the final price is confirmed after the inspection, before any work starts.
Sources and method
- SRTM (NASA) open data
- Kashf team
- Customer questions (reviewed)
- Owner price list for Makkah
- Local pages are published only after a quality gate: real local facts, text similarity of no more than 15% with any other English page, and a claims check.
- النسخة العربية